Synchronising The Alignment Of The Fork Tines With An Integrated Fork Positioner - Jungheinrich EFG 535 Betriebsanleitung

Synchronising the alignment of the fork
tines with an integrated fork positioner
(optional equipment)
Requirements
– Truck prepared for operation, (see "Preparing
the truck for operation" on page 71).
– The fork tines are no longer aligned.
Procedure
• Press the toggle switch (113) and at the same
time push the SOLO-PILOT (110) in direction
A and spread the fork tines apart as far as
they will go.
• Press the toggle switch (113) and at the same time pull the SOLO-PILOT (110) in
direction Z and bring the fork tines as close to each other as they will go.
The fork tines are now synchronised.
Z
When the limit position for the operation has been reached (there will be a noise
from the pressure relief valve) release the lever. The lever will revert automatically
to neutral.
86
110
A
Z
113