SWM SM 500 R E4 2018 Handbuch Seite 116

LOCK ADJUSTMENT
The lock can be changed, using the adjusting units
on the sides of the steering tube, as follows: loosen
the ring nut (1) and turn the adjusting screw (2) until
you have the desired angle, then tighten the ring
nut again (1). Change by the same amount on both
sides.
2
1
REAR BRAKE PEDAL POSITION ADJUSTMENT
The position of the rear brake pedal with respect
to the footrest may be adjusted according to the
individual needs.
For adjusting, proceed as follows.
- loosen the screw (1);
- turn the cam (2) in order to raise or lower the
brake pedal (3) within the range available (A);
EN - 38
- the operation done, tighten the screw (1). Once
this adjustment is completed, adjust the free play
of the pedal as follows.
2
1
3
REAR BRAKE PEDAL FREE PLAY ADJUSTMENT
The rear brake pedal (3) should have a free play (B)
(0.2 in.) before the brakes begin to bite.
Should this not happen, operate as follows:
- loosen nut (4);
- operate the pump rod (5) to increase or decrease
the free play;
- tighten nut (4) at the end of the operation.
WARNING*: When the free play requirement is
not met, the brake pads will be subjected to
an early wear that may lead to TOTAL BRAKE
INEFFECTIVENESS.
5
A
4
A
B
B
3