Scheppach HL1100GE Originalbetriebsanweisung Seite 33

• Thoroughly clean the machine after every use.
• Splitting knife
The splitting knife is a wearing part that should be
reground or replaced by a new one, if necessary.
• Two-hand control
The combined supporting and control unit must be
kept easy­going. Occasionally grease with a few drops
of oil.
• Moving parts
Keep splitting knife guides clean from dirt, wood chips,
bark etc.
Grease sliding rails with oil spray or grease.
• Checking the hydraulic oil level
Check hydraulic connections and bolts for tightness
and wear. Retighten the bolts if necessary.
• Hydraulic system
The hydraulic unit is a closed system with oil tank, oil
pump and control valve.
The system is complete when the machine is delivered,
and may not be changed or manipulated.
• Splitting spar
Before use, the spar of the splitter must be slightly
greased. Repeat this procedure every five operating
hours. Slightly apply grease of oil spray. The spar may
never run dry.
• Engine Oil
Check the oil level before each use. Remove the plug
(Fig. 13; B) and check for horizontal machine that
the oil level is between the two marks. If necessary,
add oil.
Checking the oil level
The hydraulic system is a closed system with oil tank, oil
pump and control valve. Check the lubricating oil level
before each use. Low oil level can damage the oil pump.
Note: The oil level must be checked when the riving knife
is retracted. The dipstick is located on the oil tank in the
filler cap A (Fig. 10) and is provided with two notches. If
the oil level located at the lower notch corresponds to the
minimum oil level, oil must be refilled immediately. The
top notch indicates the maximum oil level.
The splitting column must be retracted before testing, the
machine must be flat.
When must the oil be changed?
First oil change after 50 operating hours, then every 500
operating hours.
Changing the oil
1 Fully retract the splitting column.
2 Place the splitter with the two wheels off the floor onto
a pallet or something similar.
3 Carefully tilt the splitter (two people required) to the
33