Maintenance And Repair - Scheppach HL1100GE Originalbetriebsanweisung

End of work
• Move the riving knife to the lower position
• Keep the control arm off.
• Turn off the machine by turning the ignition switch
(E) to OFF.
• Close the fuel valve (B)
• Close the bleed screw.
• Observe general maintenance instructions.

Maintenance and repair

Before undertaking any maintenance or checking work,
the working area must be cleaned. Keep the necessary
tools within the reach of your hand.
The intervals mentioned herein are based on normal con­
ditions of use. An excessive use of the machine shortens
the intervals accordingly.
Clean the panels, screens and control levers with a soft
cloth. The cloth should be dry or slightly humid with a
neutral cleaning agent. Do not use any solvents like alco­
hol or benzene as they could damage the surfaces.
Store oil and grease outside the reach of unauthorized
personnel. Strictly follow the instructions on the bins.
Avoid direct contact with the skin. Rinse well after use.
Switch off the motor before undertaking any converting,
maintenance, or cleaning work.
Preventive maintenance
Turn off engine and disengage all command levers. En­
gine must be cool. Disconnect the spark plug cap from
the spark plug.
Inspect the general condition of the unit. Check for loose
screws, misalignment or binding of moving parts, cracked
or broken parts, and any other condition that may affect
its safe operation.
Remove all debris and other materials that may have ac­
cumulated to the brush. Clean after each use.
Then use a premium quality lightweight machine oil to
lubricate all moving parts.
m Never use a "pressure washer" to clean your unit. Water
can penetrate tight areas of the machine and its transmis-
sion case and cause damage to spindles, gears, bearings,
or the engine. The use of pressure washers will result in
shortened life and reduce serviceability.
Experienced craftsmen can perform minor repairs on the
machine itself.
Only professionals can perform repair and maintenance
work on the engine or hydraulic systems.
All protection and safety devices must be replaced im­
mediately after completing repair and maintenance pro­
cedures.
We recommend:
31