Operation Indication (Status Leds) - IFM Electronic Ecomot 100 Handbuch

CAN CR3101
MEM
EMCY objects
The device supports the following EMCY objects:
EMCY code Error reg
0x5000 0x81
0x5001 0x81
0x5002 0x81
0x6200 0x81
Data test
For files with default values/preset value tables a checksum is formed when the
files are created on the PC. This checksum is stored on the memory card.
With every power on or when the memory card is exchanged, the device calcu-
lates the checksum of the contents of these files and compares it with the check-
sum stored. If the two values do not match, an error message is given.
8. Operation indication
Status LED
CARD ERROR (red)
CARD ACCESS (green)
ON (green)
ERROR (red)
CAN (green)
In the initialisation phase (approx. 5 s) the LEDs indicate no defined state.
38
Additional code Description
0x0000000000 "Device hardware"
LowBatt
0x000000000 "Device hardware"
An attempt was made to write or read
although no memory card was inserted.
0x0000000001 "Device hardware"
bis For a file with preset values an error was
0x0000000010 found during a CRC check.
The number of the file 1...8 is transferred in
the additional code.
0x0000000001 "User software"
bis For one of the files the memory limit
0x0000000010 was exceeded.
The number of the file 1...8 is transferred in
the additional code.
Status Description
ON Memory card error
ON Memory card access active
OFF Supply voltage missing
ON Supply voltage ok
OFF no fault
ON CAN bus off
flashing CAN bus error / other error
OFF No relevant CAN object present
or CAN not active
or device not OPERATIONAL
ON / flashing Device OPERATIONAL and relevant
CAN object detected