Mounting; Electrical Connection - IFM Electronic Ecomot 100 Handbuch

4. Mounting

Remove the 2 caps on the sides of the data memory to fix the mounting tabs.
The screws under the caps serve to fix the mounting tabs. Choose the suitable
fixing variant A or B depending on how much space is available (→ 3. Technical
data, mounting variants).

5. Electrical connection

To ensure protection against electrical interference the CANmem housing
must be connected to the vehicle ground. This is for example ensured when
the device is fixed to conductive vehicle parts using the supplied mounting tabs.
Since the CAN interface of the CANmem is electrically separated the poten-
tial "CAN_GND" of all CAN participants must be linked. Otherwise a safe
device function is not ensured or the CAN interface may be destroyed.
In addition, the "GND" potential of the operating voltage must be separately
connected.
The DC supply cables must not exceed 10 m.
Refer to the notes on classification → 12. Declaration of conformity
Wiring → 3. Technical data, wiring
USB interface
CANmem can be used as memory card reader via the USB interface. To do so,
the "CANmem Configurator" and the USB interface cable are needed (→ 3.
Technical data, accessories).
www.ifm-electronic.com
A firmware update is always carried out via USB with the "CANmem Down-
loader".
Data sheet direct CR3101 Accessories
CAN CR3101
MEM
33