Implements - Grillo G55 Bedienungsanleitung

PROCEDURE
check the level
Engine oil
Air filter
check/adjust
Spark plug
Check the level
Gearbox oil
Check that the engine intake grid is
clean
Check blade
Cutter bar attachment
Check that tines are well-sharpened
and well-fixed
Lubricate with grease
Check clutch clearance (free play)
● recommended procedure
‫ ٭‬procedure to be carried out if necessary
ROTARY TILLER
The rotary tiller is used to break the surface layer of the ground in order to increase its permeability
and at the same time to rid of weeds. Till in first speed if the soil is hard and tough or in second
speed in soft, sandy soil. The working depth can be adjusted by lifting or lowering the central knife
located under the rotary unit. The tiller cover position will change at the same time. It is
recommendable to start tilling with the knife in the lowest position, and then to raise it if greater
depth is required. To adjust the tilling depth use the black lever on the tiller (fig. 3, n. 12).
Note: On hard soils the machine may jump forward. In this case set the central knife in the lowest
position.
CAUTION: Keep your hands and feet away from the rotary tiller hood when the engine is
running, rotation of the tiller is highly dangerous. Before performing any kind of operation
on the tiller (e.g. replacing hoes), ALWAYS SWITCH OFF THE ENGINE.
ADJUSTABLE FURROWER
This implement is specially designed for preparing furrows for sowing and irrigation (fig. 23). It is
mounted using the frame for attachments (fig. 24) like a plough on the back of the gearbox. The
furrow width can be regulated from a minimum of 10 cm to a maximum of 30 cm, by changing the
Translation of the Original Instructions
MAINTENANCE SUMMARY TABLE
EVERY 8
HOURS
●
change
check ●
replace
replace
●
replace
●
grease
●

IMPLEMENTS

AFTER EVERY
20 50
HOURS HOURS
●
● ●
● ●
●
● ●
12
EVERY ONCE A
100 YEAR OR
HOURS EVERY 200
HOURS
●
‫٭‬
●
●
●