Making An Emergency Group Call; Receiving An Emergency Group Call - Motorola MTM800 FuG ET Ausführliche Bedienungsanleitung

If the radio receives an incoming group call with emergency priority, the display shows that an emergency call
has been received, and a special audio alert is played.
An emergency group call can be configured as:
• A non-tactical call – initiated on a talkgroup preprogrammed by your service provider. When in non-tactical
emergency mode, you cannot switch talkgroups.
• A tactical call – initiated on the currently selected talkgroup.
In TMO, if the radio enters Emergency Operations while the Emergency Broadcast Call is active, the radio continues
on the call without initiating any calls and sends the Emergency Alarm.
When the Emergency Group Call you participate in terminates, your radio can behave in several ways, depending on
your service provider settings:
• If you are the call initiator, the radio can either stay in the Emergency Mode, or return to TMO.
• If you are not the call initiator, the radio always returns to TMO.

3.6.2 Making an Emergency Group Call

Prerequisites:
Ensure that your radio is in Emergency Mode.
Procedure Steps
Press and hold the PTT button.
1
2 Wait for the talk permit tone (if configured) and talk.
Release the PTT button to listen.
3
It is possible to cancel making an emergency group call in TMO. To do this, perform one of the following
actions before the talk permit is granted (depending on your service provider settings):
When the call is canceled, your radio displays Call Cancelled message (if configured by your service
provider).

3.6.3 Receiving an Emergency Group Call

The radio receives an Emergency Group Call from a selected pre-programmed group. An incoming call is indicated
by an appropriate tone, status icon, and red color of the display.
-
• Release the PTT button.
• Press the END key (default).
3.6.2 Making an Emergency Group Call
3-17