Interactions Between Control Heads; Dual Control Head Link - Motorola MTM800 FuG ET Ausführliche Bedienungsanleitung

Controls and Indicators
Menu Structure

6.10.1 Interactions between Control Heads

Your service provider can connect to one transceiver either two the same control heads (two Remote Ethernet
Control Heads, or two Telephone Style Control Heads), or two different control heads (one Remote Ethernet
Control Head and one Telephone Style Control Head).
You can use both control heads interchangeably for the same activity (for example, writing a message). If you start
an activity on one control head you can continue it on the second, provided that token is free.
Token is a right to use a key or button for a period of time. If you press a key/button on one control head, token
activates on it, and no one can press anything on the second control head until token time passes. After you release
the key/button, token becomes available again and can be taken over by the second control head. When token is
activated, Key Press Token icon is visible on the display. By default, token time is set to 3 seconds.
Token does not apply to EMERGENCY button and ON/OFF/END/HOME key. These can be pressed on
both control heads at any time.
If control heads are different, when you operate on one control head, the second one displays screen saver.
Controls and Indicators

6.10.2 Dual Control Head Link

Dual Control Head Link is a connection that occurs when both control heads are properly connected to the
transceiver and can communicate.
When the Dual Control Head Link is established, control heads play a tone and display Dual Control Head icon.
Full functionality is available on both devices.
When one control head cannot connect to the transceiver upon power up, the radio displays Single Control Head
icon and enters Single Control Head mode.
When one control head disconnects from the transceiver during operation:
• The active control head displays Link Error icon.
• The inactive control head displays Link Error and shows Link Error display (if power is available).
Turning on/off one control head results in simultaneous turning on/off the second control head.
-
6.10.1 Interactions between Control Heads
6-7