Terminal Temporary Disable/Enable; Terminal Permanent Disable - Motorola MTM800 FuG ET Ausführliche Bedienungsanleitung

Table 2-8 One-Touch Button Features (cont'd.)
Feature
Covert Mode
Horn and Lights
Initiate Call-Out Fallback Alert
RUA / RUI
Previous Talkgroup
Display OPTA
SIM Card End-to-End Encryption
GPS Status Message
Repeater Mode
Gateway Mode
Default Settings
Speaker Enable / Disable Per Call
Timed Talkgroup Change
HSM (Hearer Speaker Microphone)
Double Push PTT
If the One-Touch Button feature is enabled, the One-Touch Dial is disabled. If no feature is assigned to a
button, your radio displays theUnassigned Button message.

2.16 Terminal Temporary Disable/Enable

Your radio is provided with a feature that allows your service provider to disable it temporarily in case it is stolen.
When your radio is disabled or is powered up in disabled state, it looks and acts like it is turned off.
If your radio is found, your service provider can enable it again over the air. After your radio is enabled, you
may resume normal operation.

2.17 Terminal Permanent Disable

Your radio is provided with a feature that allows your service provider to disable it permanently in case it is stolen
or lost. When your radio is disabled permanently, it becomes inoperable. After a Permanent Disable your service
provider cannot enable your radio. It is recommended to Permanent Disable your radio only when you do not expect
to recover it. If it is recovered then a Permanent Disable radio can be reactivated by returning it to Motorola.
-
Description
Turns on/off the Covert Mode.
Turns on/off the Horn and Lights.
Sends Fallback Alert.
Logs you in/out.
Switches the radio to the previously used talkgroup.
Displays Operative Tactical Address.
Toggles on/off SIM Card End-to-End Encryption.
Sends your GPS location in a message to a dedicated address.
Turns on/off the Repeater Mode.
Turns on/off the Gateway Mode.
Resets all the radio settings to the default.
Enables speaker during the call.
Initiates the Timed Talkgroup Change feature. While in the
predefined talkgroup, it can be assigned to the second press function.
Activates/deactivates the HSM Secondary Accessory.
Sends the D- PTT tone to the talkgroup you are currently using.
2.16 Terminal Temporary Disable/Enable
2-21