Making A Group Call In Dmo; Receiving A Group Call In Idle; Private Call - Motorola MTM800 FuG ET Ausführliche Bedienungsanleitung

3.4.3 Making a Group Call in DMO

The Group Call is received by all members of the selected group who have their units turned on and are in range.
Procedure Steps
1 Press and hold the PTT button.
Wait for the Talk Permit tone (if configured) and then speak into the microphone. Release the PTT button to
2
listen.

3.4.4 Receiving a Group Call in Idle

Procedure Steps
1 The radio receives a Group Call.
The incoming Group Call is signalled by a Receiving Group Call tone.
2 To respond, press and hold the PTT button.

3.4.5 Private Call

The Private Call, also called point-to-point, or individual call, enables calling between two individuals. No other
radio can hear the conversation. This call type can be carried out in two ways:
• Duplex call (if the system allows), in TMO Mode. Both parties can speak at the same time.
• Simplex call, in TMO or DMO Mode. Only one party can speak at a time.
When a DMO Private Call takes place, radios not involved in this call receive the channel busy indication. The
radios are identified using its radio numbers.
Interaction with the accessories:
• Fist Microphone — during the Private Call, if you hang the microphone into the clip the call ends or the
audio switches to the speakers (if connected). Exact behavior depends on your service provider settings.
• Telephone Style Handset — during the Private Call, if you hand the handset into the holder, the call ends or
the audio switches to the speakers (if connected). Exact behavior depends on your service provider settings.
To end the Private Call if audio was switched to the speaker, press ON/OFF/END/HOME key.
-
3.4.3 Making a Group Call in DMO
3-11