Selective Calls; Group Ids And Wildcard Entry; Telephone Interconnect - Motorola MCS 2000 II Bedienungsanleitung

English
MCS 2000 Models II & III

Selective Calls

Receiving a Selective Call
The radio will display
CALL RECEIVED
ID: 2000
for two seconds upon receiving a Selective Call. You
can enter Selective Call to view the ID of the calling
radio and to respond with a Selective Call (see below).
Sending a Selective Call
Press the call button (12) or select the menu PRIVATE
CALL as previously described. Enter the ID via the
keypad or use the mode selector (D) to scroll to the ID
you wish to call. Press the PTT (F) to transmit the
selective call to this ID. If automatic Selective Call is
disabled, the radio exits Selective Call after the trans-
mission. If automatic Selective Call is enabled, the
radio will remain in Selective Call until you exit.
Call Alert
See trunking section for more details.

Group IDs and Wildcard Entry

(Conventional Page and Selective Call)
With keypad and unlimited calling, you may enter a
CALL RECEIVED
group ID by entering the selective call or call alert fea-
ture and then scroll backward to "group" ID entry with
the mode selector (D).
GROUP
will be displayed. You may then enter a 3-digit group
ID to call or page.
Users can enter a wildcard (
multiple IDs or groups. The '*' matches all ID digits (0-
9) in that position; i.e. to page all radio IDs 0001
through 0009, enter individual ID 0-0-0-*.

Telephone Interconnect

To make a call through the telephone system in the
conventional mode your radio must send access and
hang-up codes to the system. The access code can
be transmitted in either of two ways, depending on
how your radio is programmed.
Immediate: The radio automatically sends a pre-stored
access code as soon as the telephone intercon-
nect button (7) is pressed.
Delayed: Press the select button (13) or the PTT (F)
and the radio sends the pre-stored access
code.
After the access code is sent, you should get a dial
page 14
68P81083C10-C
*
) entry to call or page