Trouble Shooting; Disposal And Recycling; Possible Cause - Scheppach FS3600 Originalbetriebsanleitung

15. Trouble shooting

The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Fault
Diamond cutting disc comes off
when motor is deactivated.
When motor is deactivated.
Motor has no output

16. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
28 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Possible cause

Fastening nut not tightened properly
Failure of mains circuit-breaker
Extension cable defective
Connection with motor or switch is not OK
Motor or switch Is defective
Cross-section of the extension cable Is not
sufficient
Overloading
Remedy
Tighten fastening nu
Check mains circuit-breaker
Replace extension cable
Have it checked by an electrician
Have it checked by an electrician
See electrical connection, the fuse has
blown
Check tool