Blodgett SG2136G/AA Bedienerhandbuch Seite 35

POSSIBLE CAUSE(S)
SYMPTOM: Oven will not reach desired temperature.
Manifold gas pressure to too low (SG2136G).
S
Gas pressure to oven is too low (SG2136G).
S
Convection blower motor(s) not running.
S
Fuse(s) are blown.
S
Emergency stop button is pushed in (remote
S
control oven only).
Defective heating element relay (SG2136E).
S
Heating element(s) burned out (SG2136E).
S
Temperature hi-limit switch tripped (open) or out
S
of adjustment or defective.
Display: HI LIMIT TRIP --- RESET EGO
Internal problem with control.
S
*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is
recommended, however, that All repairs and/or adjustments be done by your local Blodgett service
agency and not by the owner/operator. Blodgett cannot assume responsibility for damage as a result
of servicing done by unqualified personnel.
Maintenance
SUGGESTED REMEDY
*
S
Contact local gas representative.
S
*
S
Unplug the oven power cord and check the fuses
S
(SG2136E). Call service if necessary.
Pull the button out to disengage the emergency
S
stop.
*
S
*
S
Press red EGO reset button on rear of electrical
S
box. Call service if necessary.
*
S
33
Troubleshooting Guide