Electrical Connection - Blodgett SG2136G/AA Bedienerhandbuch

Before making any electrical connections to this
unit, check that the power supply is adequate for
the voltage, amperage, and phase requirements
stated on the rating plate.
NOTE: Electrical connection must be performed
by a qualified installer only.
NOTE: The electrical installation must comply
with the national and local codes and in-
stallation requirements.
A strain relief for the supply cord is required. The
installer must provide a supply cord bushing that
meets all local and national installation standards.
A wiring diagram accompanies this manual and is
also attached to the rear of the oven.
SG2136G
SG2136G ovens require a 5 amp, 50 Hz, 1Φ,
230VAC, 3 wire service consisting of L1, neutral (or
L2) and ground. Use 75_C wire and size to Nation-
al Electric or local codes.
Connect the oven to a separate 230V, 50 Hz power
supply with a supply cord and plug or rigid con-
nection and circuit breaker. If a supply cord with
plug is used, the appliance must be positioned so
that the plug is accessible. The circuit breaker or
plug must disconnect all poles, including neutral,
with a contact separation of at least 3 mm.
Installation
SG2136E
The SG2136E requires a 15 amp, 50Hz, 3Φ,
230/400 VAC, 5 wire service consisting of L1, L2,
L3, neutral and ground.
Connect the oven to a separate 230V, 50 Hz power
supply with a supply cord and plug or rigid con-
nection and circuit breaker. If a supply cord with
plug is used, the appliance must be positioned so
that the plug is accessible. The circuit breaker or
plug must disconnect all poles, including neutral,
with a contact separation of at least 3 mm.
Connect L1 + L2 + L3 + neutral + ground.
WARNING!!
Incorrect wiring will result in extensive
damage to electrical components and
possible fire in the control panel.
THE BLODGETT OVEN COMPANY CANNOT AS-
SUME RESPONSIBILITY FOR LOSS OR DAMAGE
SUFFERED AS A RESULT OF IMPROPER IN-
STALLATION.
21

Electrical Connection