Setting The Driver's Seat; Passenger Seat; Setting The Steering Wheel Position; Refuelling - Kärcher MC 130 plus Betriebsanleitung

Check the operational and traffic safety of the vehicle before driv-
ing.
1. Fastening of the waste container.
2. Check the hydraulic and electric connections to the device car-
rier.
3. Check the spray water connections to the sweeping system
and suction mouth.
4. Check the recycling water connection to the suction mouth
(option).
5. Check the spray water filling level at the fresh water tank.
6. Recycling water filling level in waste container (option).
7. Check the sweeping system and brushes for entangled cords
and tape.
8. Check the connections at the sweeping system and suction
mouth.
9. Check the fastening of the sweeping system and suction
mouth.

Setting the driver's seat

DANGER
Danger of accident
Only adjust the driver's seat when the device is standing.
Backrest with extension
1
Pull out for height adjustment
Backrest inclination adjustment
2
Horizontal adjustment - pull the lever upwards to adjust
3
Compressor switch - for air-cushioned seat (option)
4
Right arm rest height adjustment
5
Left arm rest side adjustment
6
Left arm rest length adjustment
7
Arm rest control panel
8
Document storage
9
Lumbar support adjustment
10
Seat heater switch
11
Seat belt
12
Horizontal shock absorber
13
1. Adjust the inclination, height and position of the left arm rest
for operating the control panel.
Note
The driver's seat is automatically damped.

Passenger seat

The passenger seat is horizontally adjustable, pull the lever up-
wards to adjust.

Setting the steering wheel position

DANGER
Danger of accident
Only adjust the position of the steering wheel when the device is
standing.
Steering wheel height adjustment locking lever
1
Steering wheel inclination adjustment lever
2
Brush contact pressure pedal
3
1. Pull and hold the inclination adjustment lever and set the
steering wheel to the desired inclination.
2. Push in the lever.
3. Release the height adjustment locking lever and set the steer-
ing wheel to the desired height.
4. Lock the locking lever.
DANGER
Risk of explosion
Do not refuel in confined spaces.
Do not smoke and avoid open flames.
Ensure that no fuel gets on hot surfaces.
1. Switch off the ignition.
2. Open the tank cap.
3. Fill with fuel.
Only the fuel specified in the operating instructions may be
used.
4. Wipe of any spilt fuel and close the tank cap.

Refuelling with the fuel canister

Estimate the required amount of fuel in advance to avoid over-
flows.
Filling the water reservoir for a water circulation
system/recycling mode (option)
Note
With a water circulation system (Recycling mode), water is direct-
ly filled into the waste container.
1. Open the filling hole and water drain opening on the waste
container.
2. Fill with water until it escapes from the water drain.
3. Close both openings.
4. Switch on recycling mode at the control panel.
English

Refuelling

71