Kärcher MC 130 plus Betriebsanleitung Seite 88

Retaining pins
1
Locking pin
2
Storage for safety bolts with safety bracket (2x)
3
Secured position (1x right, 1x left)
4
1. When the waste container is raised, use safety bolts and se-
cure with the safety brackets (2x).
Securing the tipping device
Piston rod
1
Locking pin
2
Safety bracket
3
Safety bracket mount
4
1. Raise the tipping device all the way.
2. Open the locking pin.
3. Remove the support from the bracket.
4. Insert the bracket.
5. Fit the locking pin.
Note
Locking pins can be applied to the left and right piston rods.
Lowering the tipping device
ATTENTION
Damage to the suction hose
When lowering the tilting frame, make sure that the suction hose
goes into its guide properly.
88
Suction hose
1
1. Lower the tilting frame after removing the safety support.
2. If necessary, manually insert the suction hose into the guide.
Removing the side cladding
WARNING
Risk of burns!
Allow the vehicle to cool down sufficiently before removing any
panels.
Side panel latches
1
Side panel
2
Switchover valve cover
3
1. Remove the switchover valve cover.
2. Set the switch lever to the "Lifting platform" position, see chap-
ter Hopper/lifting platform switchover.
3. Raise the lifting platform approx. 15 cm.
4. Open both side cladding locks.
5. Lift the side cladding upwards and take it off sideways.
Installation information
Installation is performed in reverse sequence.
English