Sweeping System - Kärcher MC 130 plus Betriebsanleitung

8. Open and remove the locking pin.
9. Pull out the retaining pin.
10.Raise the lifting platform with waste container.
11.Fit the front mounting supports.
12.Lower the loading platform.
Note
The waste container now stands free on the installation supports.
13.Drive the rear of the vehicle carefully out from under the waste
container.

Sweeping system

Removing the sweeping system
A changing carriage is required for attaching/removing the
sweeper system.
Note
Optional accessory, order no. 2.852-065.0.
1. Stop the vehicle on level, solid ground and secure it against
rolling away.
2. Raise the side brushes and extend both side brushes out-
wards.
Brush system unlocked lever position
1
Brush system locked lever position
2
Vehicle front
3
(1)Rod
(2)Locking lever
3. Unlock the sweeping system by inserting the rod and pulling
the locking lever upwards.
The rod needed for this is clamped in a holder between the
driver's seat and passenger seat.
82
4. Use the lift truck to move the changing carriage centrally in-
wards as far as it will go.
Move the last distance (centring process) faster.
Note
Risk of damage! Watch out for cables and hoses.
5. Raise the lift truck until the changing carriage makes contact
with the sweeper system.
Side brush arm
1
End stop
2
6. Retract both side brush arms.
7. Check the side brush arms for correct seating.
8. Lower the suction mouth.
9. Set the ignition to position 1 in Work mode (do not start the en-
gine).
The brushes lower and the hydraulic system depressurises.
10.Disconnect all connections and joints.
11.Remove the suction hose between the waste container and
suction mouth.
12.Disconnect the (thick) water hose.
13.Move the sweeper system out using the lift truck.
Storage box
1
Cables and hoses
2
14.Place the cables and hoses in the storage boxes.
15.Park the sweeper system in a safe place.
16.Extend the lift truck.
English