Multiswitch; Travel Direction Lever; Pedals - Kärcher MC 130 plus Betriebsanleitung

Operating hours counter
6
Working hours symbol (no function)
7
Working hours meter
8
Working speed
9
Mileage
10
Date and time
11
Travel direction backwards
12
Forwards direction of travel
13
Rear attachment drive triggering level in %
14
Preheating coil symbol
15
Engine coolant temperature
16
Battery charging monitor warning light
17
Engine oil pressure warning light
18
Parking brake warning light actuated
19
Hydraulic oil temperature
20
Fuel level indicator
21
Depressurise the hydraulic system (pressure relief)
The hydraulic system must be depressurised before disconnect-
ing the hydraulic hoses from the hydraulic connections.
1. Unplug the signal plug for attachment device detection (front).
2. Switch on the ignition (do not start the engine).
3. Switch on the PTO (at the arm rest control panel).
4. Press function key F 10.
5. Press function key F 6. Hydraulic system is depressurised.
6. Disconnect the hydraulic hoses.
7. Remove the attachment device.
Note
Attachment is performed in reverse sequence.

Multiswitch

 Horn: Push the lever up.
 Right turn signal: Lever up
 Left turn signal: Lever down
 High beam: Push down the lever with the high beam switched
on
 Flashing: Pull the lever
 Turn the ring: Switch on the windscreen wiper (intermittent
and constant)
 Press the ring: Wiping with wiping water

Travel direction lever

1
Select the driving direction with the travel direction lever.
The following functions can be selected using the travel direction
lever, the selected programs are shown on the display.
 Neutral position
Travel direction lever in the middle
 Forwards direction of travel
Press travel direction lever upwards and push forwards
 Travel direction backwards
Press travel direction lever upwards and pull backwards
 Switchover between the fast (Hare) and slow (Tortoise) oper-
ating programs
Push the travel direction lever to the end position (travel direc-
tion lever must be in the neutral position).
Accelerator
1
Brake pedal
2
Brush contact pressure/brush speed lever
3
ATTENTION
Other than in a normal motorcar, releasing the accelerator pedal
abruptly reduces the speed.
The braking force applied when you release the accelerator ped-
al is weaker in higher gears and stronger in lower gears.
The braking force applied when you release the accelerator ped-
al in transport mode is significantly weaker than in working mode.
Pressing the accelerator pedal increases the engine speed.
The accelerator pedal is sprung. Releasing the accelerator pedal
reduces the engine speed.
The hydrostatic drive brakes or stops the vehicle when the accel-
erator pedal is released.
The brake pedal activates the braking system for the front
wheels.
English
Travel direction lever

Pedals

Accelerator
MIC 50 brake pedal
67