Error Messages For Symbol Displays - Kärcher MC 130 plus Betriebsanleitung

Malfunction
Motor is running erratically
Motor is running but machine is
not moving or moving slowly
Motor does not switch off (main
switch to 0)
Dust during sweeping/insuffi-
cient suction performance
Unsatisfactory sweeping perfor-
mance
Side brushes cannot be activat-
ed
Side brushes do not turn
Emptying of waste container not
working
Note
In case of all malfunctions not listed, contact Customer Service!
Malfunction
96
Remedy
 Clean or replace air filter.
 Check, clean and/or replace fuel filter.
 Top up fuel, bleed the fuel system.
 Check the fuel connections and lines.
 Contact the authorised Customer Service.
 Release parking brake.
 Check setting of freewheel lever.
 Have the oil level for the traction hydraulics checked by Customer Service.
 During minus temperatures and with cold hydraulic oil: Allow machine to warm up for at least for 3
minutes.
 Clean fuel cock on fuel filter.
 Attach the fuel pump.
 If this keeps occurring, contact Customer Service.
 Empty waste container.
 Switch on the suction blower.
 Check hose on suction fan.
 Check/replace seals:
a Sealing cover on suction fan.
b Filter box seal.
c Waste container seals.
 Checking/cleaning/replacing dust filter.
a Check that the dust filter is secured correctly.
b Clean the dust filter in case of slight soiling.
c Clean the dust filter in case of damage or replace it in case of heavy soiling.
 Check/adjust the sealing strips for wear, replace as necessary.
 Check roller brush and side brushes for wear, replace if necessary.
 Check sealing strips for wear, adjust or replace as required.
 Check function of coarse dirt flap.
 Check the sweeping roller half sections for proper seating.
 Check filling level of hydraulic oil tank.
 Check the hydraulic system for tightness.
 Contact Customer Service.
 Check filling level of hydraulic oil tank.
 Check the hydraulic system for tightness.
 Check the side brushes for wrapped belts.
 Contact Customer Service.

Error messages for symbol displays

Cause
Motor overheated.
Hydraulic oil temperature too high.
Hydraulic oil temperature too low .
Motor oil pressure too high.
Parking brake active.
Remedy
 Set motor speed to idle mode.
 Clean cooler (see section Care and maintenance)
 Check the fill level of the coolant in the motor.
 If the warning light does not go out within 5 minutes:
a Switch off motor.
b Contact Customer Service.
 Let the motor idle until the warning light goes out.
 Let the motor warm up carefully until the warning light
goes out.
 Contact Customer Service.
 Release parking brake.
English