Kärcher MC 130 plus Betriebsanleitung Seite 69

Water circulation system / recycling mode
Suction mouth
1
Recycling water hose
2
Suction hose
3
Waste container
4
In recycling mode, the suction hose is continuously cleaned by
water from the waste container.
The water is filtered by a pipe filter in the waste container and
then channelled through the recycling water hose to the suction
mouth via a valve.
This recycling water is immediate sucked in again at the suction
mouth and then channelled back to the waste container through
the suction hose.
The suction hose is continuously cleaned.
Manual suction hose attachment kit
Manual suction hose attachment kit
1
High-pressure cleaner, brush and dirt scraper attachment kit
Brush and shovel
1
High pressure cleaner
2
Dirt scraper
3
Note
When retrofitted, the brackets must be installed and also the side
panel cutouts for holding the brush and shovel handles.
Drive light/direction indicator attachment kit
Drive light/direction indicator attachment kit
1
These are switched on and off via a special switch in the ceil-
ing control panel.
Driving light/flasher
2
The suction mouth camera is fastened under the front power lift.
The reversing camera is located at the rear of the vehicle.
WARNING
The reversing camera is no substitute for an awareness of
the surroundings
Always pay attention to the surroundings when reversing.
Ensure no persons, animals or objects are located in the ma-
noeuvring range.
English
Suction mouth camera
Reversing camera
69