Submenu "Camera; A) Function "Pairing - Sygonix 1486623 Bedienungsanleitung

14. Submenu "Camera"

• As described in chapter 10, briefly push the button "MENU" (6) to call the OSD menu. Then use the control buttons
" " or " " to select the corresponding submenu and push the button "OK" (9) to confirm.
• Use the control buttons "
• To return to the prior menu or to leave the OSD menu, briefly push the button "MENU" (6) (repeatedly if necessary).

a) Function "Pairing"

Use the "Pairing" process to register the radio camera at the screen/DVR. This means that the radio camera will only
send its camera image to a single screen/DVR; other devices have no access to the camera image.
The enclosed radio camera is usually paired with the screen/DVR ex works, so that pairing is no longer required.
However, if you purchase additional radio cameras separately (the screen/DVR can be operated with four radio cam-
eras in total), they must be paired with the screen/DVR.
Each radio camera can be logged on to only one screen/DVR for reasons of safety. It therefore is not pos-
sible to play back the signal of a radio camera on two or more screens/DVRs.
Only one radio camera can be logged on to each channel of the screen/DVR. If a radio camera has already
been registered at a channel, a new registration of a new radio camera will overwrite the present one.
Since only 35 seconds are available for logging on for reasons of safety, the screen/DVR and radio camera
should be in direct proximity to each other (minimum distance 1 m). Alternatively, the login process must be
performed with a second person.
Proceed as follows for teaching:
• First connect the radio camera to the voltage/power supply if you have not done so yet.
• After calling the function in the screen/DVR, select one of the four camera memory slots that is not occupied yet
with the control buttons "
• Push the "OK" (9) button to start pairing.
• Within the next 35 seconds, you need to push the pairing button (22) on the rear of the radio camera for 2 seconds.
• After the end of 35 seconds, a confirmation message appears in the LC display of the screen/DVR to indicate
whether pairing was successful or not.
• Briefly push the button "OK" (9); then another radio camera can be taught in; then proceed again as described
above.
• Push the "MENU" (6) button to leave the pairing mode. Then the screen/DVR will restart and will be ready for
operation after a few seconds.
The screen/DVR should now display the camera image of all registered radio cameras.
If pairing is not completed successfully, check if the radio camera is connected to the voltage/power supply
(power LED (29) at the front of the radio camera is lit). Reduce the distance between the radio camera and
screen/DVR. Then start pairing again.
" or " " to select the desired function now. Confirm the selection with "OK" (9).
" or " ".
77