I) Function "System Information; J) Function "System Upgrade; K) Function "Scan Mode Period; L) Function "Mute - Sygonix 1486623 Bedienungsanleitung

i) Function "System information"

• After calling the function, the screen/DVR shows the firmware version and other information.
• Use the "OK" (9) button or the "MENU" (6) button to leave display mode again.

j) Function "System upgrade"

This function can be used to update the firmware of the screen/DVR and the cameras.
For this, it is necessary that you store the firmware update on a memory card and then insert it into the
screen/DVR.
If a firmware update is available, it can be found in the download area on our product website online under
www.conrad.com.
• After calling the function, use the control buttons "
firmware (screen/DVR or radio cameras).
• Use the button "OK" (9) to confirm your selection (a small check mark is displayed if a firmware update is to be
performed).
• To start the firmware update, push the "REC" (18) button. A safety prompt appears.
• Use the "OK" (9) button to start the firmware update. Alternatively, push the "MENU" (6) button to return to the
previous menu (cancel).

k) Function "Scan mode period"

Use the "LOOP" (19) button to activate automatic switching between camera images (channels). The time for how
long the respective camera image is displayed can be set in this function.
• After calling the function, you can set the desired duration with the control buttons "
• Save the selection with the button "OK" (9); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), briefly push the button "MENU" (6). The display
will switch back to the prior menu.

l) Function "Mute"

This function activates muting so that, e.g., the alarm sound at motion detection is temporarily deactivated without
needing to change the settings for the alarm sound.
• After calling the function, you can use the control buttons "
• Save the selection with the button "OK" (9); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), briefly push the button "MENU" (6). The display
will switch back to the prior menu.
70
" or " " to select the device for which you want to update the
" or " " to switch muting on or off.
" or " ".