M) Function "Load Default; N) Function "Brightness; O) Function "Volume; P) Function "Alarm Volume - Sygonix 1486623 Bedienungsanleitung

m) Function "Load default"

With this, you can reset all settings in the screen/DVR to the factory settings.
• After calling the function, use the control buttons "
settings or not (cancel).
• Accept the selection with "OK" (9). Alternatively, push the "MENU" (6) button to return to the previous menu (cancel).

n) Function "Brightness"

To adjust the backlighting of the LC display to the ambience conditions, the brightness can be set in several steps.
• After the function is called, the brightness can be changed with the control buttons "
• Save the selection with the button "OK" (9); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), briefly push the button "MENU" (6). The display
will switch back to the prior menu.

o) Function "Volume"

The radio camera used does not have any microphone; therefore, setting of the on the screen/DVR is irrelevant. If
the volume is set higher, there may, however, be a slight hum in the installed speakers. Therefore, adjust the volume
to the lowest position.
• After the function is called, the volume can be changed with the control buttons "
• Save the selection with the button "OK" (9); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), briefly push the button "MENU" (6). The display
will switch back to the prior menu.

p) Function "Alarm volume"

This setting applies to the volume of the alarm sound when the motion alarm is switched on and a motion occurs in the
recording range, or if the PIR alarm is switched on and a heat change occurs in the recording area.
This setting is independent from the setting in chapter 11. o).
If muting (see chapter 11. l) is active, the alarm sound is muted as well.
• After the function is called, the alarm tone volume can be changed with the control buttons "
• Save the selection with the button "OK" (9); then you will leave setting mode again.
To leave setting mode without saving the settings (cancel), briefly push the button "MENU" (6). The display
will switch back to the prior menu.
" or " ", to select whether you want to restore the basic
" or " ".
" or " ".
" or " ".
71