Sygonix 1486623 Bedienungsanleitung Seite 89

Network does not work
• Check the connection between the screen/DVR and the RJ45 network adapter.
• Before you switch on the screen/DVR, the RJ45 network adapter must be connected and the network connection
with the router/switch must be established.
• Try connecting the screen/DVR directly to the router instead of the network switch.
• Always use a 1:1-connected, fully wired network cable.
• Depending on your network, either select DHCP in your network settings or set a fixed IP-address.
When there is a DHCP server in your network (usually integrated in nearly any router), set the DHCP function at the
screen/DVR as well. The screen/DVR then receives the required IP address from your DHCP server.
If you are using fixed IP addresses, assign an unused UP address from the same address range to the screen/DVR.
• If you have changed the network setting, switch off the screen/DVR and switch it on again after a few seconds.
• A firewall prevents the function of the screen/DVR.
89