8. Repeat the above steps for other trigger parameters.
9. Press the SNOOZE/LIGHT button to exit anytime.
b) View current alarm settings
1. Press and hold the ALARM button for approx. 3 seconds to enter alarm mode.
2. Press the ALARM button to toggle between upper/lower trigger values.
- The presence of the alarm icon next to a value indicates that the alarm is activated.
- Press the SET button to toggle between: [ Outdoor temperature / Dew point ] / [ Absolute
pressure / Relative pressure ]
3. Press the SNOOZE/LIGHT button to exit anytime.
c) When the alarm is triggered
•
When the alarm is triggered, the alarm icon of the corresponding trigger parameter flashes
in the display and the beeper sounds.
- The beeper can be enabled and disabled. See chapter '11. Settings' on page 54 for
details.
•
To silence the beeper, press any button.
•
To silence the beeper of the alarm clock you can either snooze it with the SNOOZE/LIGHT
button, or cancel it by pressing any other button. See section 'd) Snooze alarm clock' on
page 60 for details.
d) Snooze alarm clock
The alarm clock is the only parameter that can be snoozed.
Press the SNOOZE/LIGHT button to snooze the alarm. The alarm goes off, the backlight
•
switches on, and the icon flashes in the display.
•
The alarm sounds again in approx. 5 minutes.
•
To turn off the alarm completely, press the HISTORY/–, SET, ALARM or CHANNEL/+
button.
60