9. Outdoor sensors
When you add a sensor for the first time, take the following steps in sequence:
1. Select a channel.
2. Set the temperature unit.
3. Install the batteries.
4. Repeat the above steps if you have more than one sensor to set up.
5. Link the sensor(s) to the weather station.
Keep the battery compartment open until you have added the sensor to the weather
station.
a) Select a channel
Make sure no two sensors use the same channel.
It is necessary to remove the batteries when selecting the channel in order to restart
the sensor.
1. Remove the battery compartment screw of the battery compartment (A3) with a cross-head
screw driver.
2. Lift the battery compartment cover up.
3. Remove the batteries (not applicable to first time setup).
4. Use the dip switch to select a channel. Refer to below diagram.
Channel 1
Channel 2
Channel 5
Channel 6
5. Insert the batteries (not applicable to first time setup).
6. Replace the battery compartment cover.
50
Channel 3
Channel 4
Channel 7
Channel 8