Alarm; A) Set Trigger Parameter - Eurochron EFWS5008 Bedienungsanleitung

14. Alarm

Alarms notify you if currently measured values exceed or fall below preset threshold values.
Trigger parameter pairs such as (lower outdoor temperature, upper outdoor temperature) can
be individually enabled and disabled.
Only weather station and channel 1 are supported for alarms.

a) Set trigger parameter

Note the display icons: LOW for lower value / HI for upper value
Trigger parameter
Hour / Minute (Alarm clock)
Outdoor temperature
Outdoor humidity
Dew point
Indoor temperature
Indoor humidity
Absolute pressure
Relative pressure
1. Press the SNOOZE/LIGHT button to enter normal mode.
2. Press and hold the ALARM button for approx. 3 seconds to enter alarm mode.
- If no user input is registered for 30 seconds, the display enters normal mode again.
3. Press and hold the SET button until the hours of the clock flash.
4. Repeatedly press the SET button until you reach the trigger parameter for which you like
to be notified.
5. Press the HISTORY/– or CHANNEL/+ buttons to set the trigger thresholds (e.g. upper
temperature and lower temperature).
6. Press the ALARM button to activate the alarm for the trigger threshold (upper/lower). The
corresponding alarm icon shows on the display next to the measured/displayed value.
- Press the ALARM button again to deactivate the alarm for the trigger parameter. The
alarm icon fades out from the display.
7. Press the SET button to go to the next trigger parameter.
Trigger threshold
Alarm time
exceeds upper value
falls below lower value
Alarm icon Snoozable
Yes
No
No
59