D) Link Sensor To Weather Station; E) Data Transmission Indicator; Operation; Backlight - Eurochron EFWS5008 Bedienungsanleitung

d) Link sensor to weather station

The weather station must be powered on when linking sensors. If you have multiple unlinked
sensors, they will be linked one after the other. Take the following steps on the weather station:
1. Hold down the CHANNEL/+ button (B5) until
2. Press the HISTORY/– (B8) or CHANNEL/+ button to select
- If you want to relink an individual sensor, for example after a loss of signal, select the
corresponding channel.
- Signal loss is displayed as --.- in the display.
3. Press the SET (B7) button to exit.
4. Channels are now being linked up to the weather station, one after the other. During linking
the sensor signal

e) Data transmission indicator

A sensor transmits data to the weather station every 60 seconds. The indicator light (A6) gives
a quick flash.

10. Operation

a) Backlight
Press the SNOOZE/LIGHT (B9) button to activate the backlight for a few seconds.
•
Press and hold the SNOOZE/LIGHT button for approx. 2 seconds to turn on the backlight
•
permanently. LED ON is displayed briefly. Press and hold the SNOOZE/LIGHT for approx. 2
seconds to turn the permanent backlight off again. LED OFF is displayed briefly.

b) Switch between outdoor sensors

• Press the CHANNEL/+ button repeatedly to switch between the outdoor sensors (Channels
1 - 8), and sensor scroll mode
- Sensor scroll mode
• In sensor scroll mode, the icon
be displayed in 5 second intervals.

c) Toggle display values

1. Press the SET button. The first setting flashes.
2. Press the HISTORY/– or CHANNEL/+ button to adjust setting.
52
icon (C3) will show in the display for at least 3 minutes.
.
requires at least 2 sensors.
shows in the display and individual sensor readings will
shows in the display.
.