Setting Time Zone; Setting Alarm Time - Eurochron FWS-1600 Bedienungsanleitung

would strongly advise you not to remove the upper battery
outside the range of the DCF signals. Otherwise the clock will
continuously
100

Setting time zone

95
After the device has received the DCF signal and been set to the
correct time, you can adjust the time zone, e.g. when you wish to
75
take the device with you on holiday.
For this press the LIGHT button for 6 seconds. Then the hands are
moved forwards by 1 hour, i.e. "+1" time zone ahead. Now press
the LIGHT button once briefly for each time zone by which the
25
device is to move forward. When you do not press the button for
any longer than 6 second, the time zone setting is ended.
5

Setting alarm time

0
The device can emit an acoustic signal at two particular times,
e.g. in order to wake you.
Ø
In order to program this time, turn the knob clockwise only in
order to set the alarm time. In this way set the alarm hand on
the clock face to the alarm time desired.
Ø
Make sure that the ON / OFF switch is set in the ON position.
Otherwise the alarm function is deactivated.
Ø
At the time entered the acoustic signal sounds for 2 minutes.
You can end the alarm before this by pushing the ON / OFF
switch onto the OFF position. However, the alarm time is
saved, and will set off the signal on the following day if you
push the ON/OFF switch into the ON position after approx. 2
hours.
Ø
If you only wish to briefly interrupt the alarm, e.g. in order to
continue snoozing a little, press the LIGHT button on the top
100
of the device. The alarm signal is then repeated after 5
minutes, unless you switch off the display in the meantime.
95
Setting time and date in the LCD
75
Independently of the radio-controlled analogue clock, you can
display time and date in the bottom line of the digital display.
Toggling between time and date is carried out by briefly pressing
the MODE
25
Hold the MODE button pressed down for 3 seconds.
5 flashes in the display and requests you to determine with the
+/— buttons whether the time display should be given in 12- or
24-hour format. Briefly press the MODE button in order to
0
display 12:00.
button.
20
20
24 HR
now
100
95
75
25
5
0
100
95
75
25
5
0