Stopping The Alarm Signal; Snooze Function; Temperature Alarm - Conrad TE635EL Bedienungsanleitung

Stopping the alarm signal

To stop the alarm signal which sounds at the set alarm time, briefly press the "ALARM" button.

Snooze function

When the alarm sounds at the set time, you can activate the snooze function by briefly pressing
the "SNOOZE/LIGHT" button on the top of the weather station.
This interrupts the alarm signal for about 8 minutes before it starts again.
Now you can reactivate the snooze function again, if you still do not want to get up.

If the alarm signal is not stopped within 2 minutes by briefly pressing the
"ALARM" button, the snooze function is automatically activated. This happens
three times in succession, then the alarm function stops.
r) Temperature alarm
You can set an upper and a lower limit for the temperature on the weather station, from which
on a tone signal is emitted.

The temperature alarm is only emitted if the temperature is either below or
above the set limit at an outdoor sensor (not at the weather station).
If a tone signal is emitted at a temperature alarm, this can be stopped by briefly pressing the
"TEMP AL" button.
To set an upper or lower limit for the temperature, proceed as follows:
• Press the "TEMP AL" button to switch between the display of the upper limit, the lower limit
and the normal display.
• When the upper or lower limit is displayed, you can change it. To do this, hold the "TEMP
AL" button down (approx. 2 seconds) until the displayed value flashes.
• Set the temperature limit with the " " and " " buttons on the front of the weather station.
• Confirm the setting by briefly pressing the "TEMP AL" button.
79