Stopping Alarm Signal; Snooze Function; Temperature Alarm - Conrad WS 624 Bedienungsanleitung

Stopping alarm signal

To stop the alarm, which sounds at the set alarm time, briefly press the "ALARM ON/OFF"
button.

Snooze function

When the alarm sounds at the set time, you can activate the snooze by briefly pressing the
"SNOOZE • LIGHT" button on the top of the base station.
This interrupts the alarm for about 8 minutes before it starts again.
Now you can reactivate the snooze function again, if you still don't want to get up.
If the alarm is not stopped within 2 minutes by briefly pressing the "ALARM ON/
OFF" button, the snooze function is automatically activated. This happens three
times in succession, then the alarm stops.
r) Temperature alarm
You can set an upper and a lower limit for the temperature on the base station, from which on
a tone signal is emitted.
The temperature alarm is only emitted if the temperature is either below or above
the set level at an outdoor sensor (not at base station).
If a tone signal is emitted at a temperature alarm, this can be stopped by briefly pressing the
"TEMP AL" button.
To set an upper or lower limit for the temperature, proceed as follows:
• Press the "TEMP AL" button to switch between the display of the upper limit, the lower limit
and the normal display.
• When the upper or lower limit is displayed, you can change it. To do this, hold the "TEMP AL"
button down (approx. 2 seconds) until the displayed value flashes.
• Set the temperature limit with the " " and " " button on the front of the base station.
• Confirm the setting by briefly pressing the "TEMP AL" button.
78