Snooze Function („Snooze"); Stopping The Alarm Signal; M) Bargraph Display For Barometric Pressure Development; N) Weather Trend Display - Conrad S3318P Bedienungsanleitung

Snooze Function („SNOOZE")
Once the alarm signal for the set waking time has been started,you may activate the snooze
function by briefly pushing the button „SNZ/LIGHT" (6). The backlighting also lights up for
approx. 10 seconds.
The alarm signal is then interrupted for about 5 minutes. During this time, the icon „
time 1) or „ " (alarm time 2) flashes, as well as the icon „Z
2
After the end of 5 minutes, the alarm signal starts again.
The snooze function works several times in sequence.

Stopping the Alarm Signal

To stop the alarm signal, push any button on the front of the weather station (except for
„SNZ/LIGHT" (6); it activates the snooze function; see above).

The alarm signal is automatically terminated after 2 minutes without any button being
punished.

m) Bargraph Display for Barometric Pressure Development

In the left area of the LC display of the weather station, a bar chart display (D) shows the air
pressure trend of the last 12 hours as a chart.

After inserting the batteries into the weather station, no measured values are present
obviously, and all bars are the same height.

n) Weather Trend Display

An arrow for the weather trend (A) is displayed in the upper left of the display. The calculation
basis is the barometric pressure progress of the last 12 hours.
Improvement of weather Consistent
" (E) above it.
Z
Deterioration of weather
" (alarm
1
53