C) Setting The Alarm Clock; D) Switching Alarm Clock On/Off; E) Activate The Snooze Function ("Snooze"), Stopping The Alarm Clock; F) Max/Min Display For Indoor Temperature/Indoor Humidity - Conrad WS-8035IT Bedienungsanleitung

c) Setting the alarm clock

• Press and hold the "ALM/DATE" button (approx. 3 seconds) until the time of the alarm flashes on the right next
to the display of the moon phases.
• Set the hour of the wake time with the "IN" button (press and hold button longer for quick setting)
• The "OUT/+" button sets the minutes of the wake time (press and hold button longer for quick setting).
• Confirm the setting by briefly pressing the "SNOOZE/CH" button.

d) Switching alarm clock on/off

• Briefly press the "ALM/DATE" button in order to switch the alarm on or off.
• If the alarm clock is switched on, the time of the alarm and the icon for the alarm function will be displayed on the
right next to the display of the moon phases.
If the alarm clock is switched off then the display of the day of the week and that of the date are displayed instead.

e) Activate the snooze function ("SNOOZE"), stopping the alarm clock

The max. duration of the alarm signal is approximately 2 minutes.
While the alarm resounds, the snooze function can be activated for 10 minutes by pressing the "SNOOZE/CH" button.
The alarm clock is interrupted for 10 minutes and restarts afterwards.
If the alarm clock is in the snooze mode, the latter is indicated through the flashing of the alarm clock icon "((•))".
In order to interrupt the snooze mode and the alarm clock simultaneously (until it rings on the following day), you can
press any button except the "SNOOZE/CH" button.
The alarm clock can be stopped during the ringing of the alarm signal by pressing any button except the "SNOOZE/
CH" button.
If the alarm clock is not switched off (see d), the alarm clock will ring the following day at the set time.

f) MAX/MIN display for indoor temperature/indoor humidity

Briefly press the "IN" button in order to switch between the display of the MAX values, the MIN values and the present
measured values.
The Max and the MIN value at the time of occurrence (time and date) will be indicated in the display simultaneously.
In order to erase the MAX or the MIN value, press the "SET" button for approximately 3 seconds while the
corresponding value is indicated in the display. The saved value will be reset according to the present measured
value.
49