Setting The Alarm; C) Switching Off The Alarm Tone; D) Searching/Connecting The Outdoor Sensor; E) Display Of The Weather Data From Outdoor Sensors - Conrad 67 20 91 Bedienungsanleitung

b) Setting the alarm
• Press the button "WEATHER" (7) button (on the remote control)
• Press the "SETUP" (6) button
• Use the "◄" / "►" buttons to select the alarm setting
• Activating/deactivating the alarm. A deactivated alarm is indicated by the crossed out bell symbol
• Set the alarm time you want using the "◄" / "►" / "▲" / "▼"
• If the alarm has been activated, an alarm tone sounds at the set time.

c) Switching off the alarm tone

• Press any key on the remote control or on the radio colour table clock

d) Searching/connecting the outdoor sensor

• Press the button "WEATHER" (7) button (on the remote control)
• Press the "SETUP" (6) button
• Use the "◄" / "►" buttons to select the setting for searching for remote control sensors
• The outdoor sensor channel display (blue fi eld in front of the display for the outdoor sensor weather data) fl ashes
• Switch on the outdoor sensor and/or press the "Reset" (27) button on the outdoor sensor
• Then press the "CH" (24) button until the desired channel (1 – 5) appears at the bottom left of the outdoor sensor
display
• Within 2 minutes, the atmospheric temperature and atmospheric humidity of the detected outdoor sensor appears
at the bottom right of the radio colour table clock display
You can connect the radio colour table clock to up to 5 outdoor sensors. Each outdoor sensor then has
to be set to a different channel (1 - 5). If the outdoor sensor has also received a DSF receiver module,
the time and the date will also be synchronised with the DCF signal after some time. The radio colour
table clock displays the DCF symbol to indicate that the time and date is now synchronised with the DCF
signal. The DSC symbol does not appear if the time and the date have been set manually.

e) Display of the weather data from outdoor sensors

You can connect the radio colour table clock to up to 5 outdoor sensors. The "ENTER" (1) button allows you to toggle
between the automatically changing display of all outdoor sensors or the display of one outdoor sensor. The channel
of the outdoor sensor shown appears in the blue fi eld in front of the display. The "◄" / "►" buttons enable you to
toggle between the various outdoor sensors/channels.
32