Setting Up The Transmitter; A) Select Remote Control Mode - Reely Slow Flyer II Bedienungsanleitung



9. Setting Up the Transmitter

In practice, it has turned out helpful to first take the transmitter into operation and then charge the flight
battery with the transmitter. The model can be competed during charging.

a) Select Remote Control Mode

With the help of the mode switch (also see figure 1, item 3), the remote control cannot be operated in mode 1 or mode
2. If the switch is pushed to the left position, mode 1 is activated. If the switch is pushed to the right position, mode 2 is
activated.
The two modes differ only by assignment of the control functions
of the respective control lever.
Mode 1:
• Right control stick forward and backward:
Motor function (THRO)
• Right control lever right and left:
Rudder function (RUDD)
• Left control stick forward and backward:
Elevator function (ELEV)
Mode 2:
• Right control stick forward and backward:
Elevator function (ELEV)
• Right control lever right and left:
Rudder function (RUDD)
• Left control stick forward and backward:
Motor function (THRO)
Other information on model control can be taken from the section "Checking the Control Functions".
Attention, important!
In contrast to the control lever for the rudder and elevator function, for which the lever is kept in the centre
position by spring force, the control lever for the motor function will always stop in the last position set.
Therefore, the control lever for the motor function must be put in the centre position before the mode switch
is operated (figure 1, item 3). To prevent the drive motor of the model from starting up unintended, neither the
transmitter nor the model must be in operation during mode switching.
36
Figure 2