Setting Up The Transmitter; Commissioning Of The Transmitter; Inserting The Batteries - Reely L400 Bedienungsanleitung

9.

Setting up the Transmitter

In the further course of these instructions, figures in the text always refer to the adjacent figure or the figures
within the section. References to other figures are indicated with the corresponding figure number.
a) Inserting the Batteries
For the power supply of the transmitter you will need 4 alkaline batteries (e.g. Conrad item no. 652507, pack of 4,
order 1) of the size AA/mignon.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back of
the transmitter. Lift the lid at the lower edge in the area of
the latching tab (2) and fold it open upwards.
Ensure that the polarity is correct when inserting the 4 bat-
teries. A corresponding note (3) is located on the bottom
of the battery compartment.
Then fold the lid of the battery compartment back down
and push it closed so that the latching tab latches again
safely.
Figure 2
43