Setting Up The Transmitter; Inserting The Batteries - Reely 1551510 Handbuch

10. Setting up the Transmitter

a) Inserting the Batteries
The power supply of the transmitter requires 2 AAA/micro batteries (e.g. Conrad, item no. 652303, please order 2x).
Proceed as follows to insert the batteries or rechargeable batteries:
The battery compartment lid (1) is located on the back of
the transmitter. Use a suitable screwdriver to turn out the
attachment screw (2) at the battery compartment lid and
push the lid off downwards.
Insert the batteries observing the correct polarity accord-
ing to the note in the battery compartment (3). The spiral-
shaped spring contact (4) always must be connected to
the minus pole of the battery.
Push in the battery compartment lid again from below and
tighten the retention screw (2).
Figure 7
36