Inserting The Batteries; C) Checking The Transmitter's Power Supply - Reely Slow Flyer II Bedienungsanleitung

b) Inserting the Batteries
Important!
Only operate the remote control transmitter with batteries with a voltage of 1.5 V/cell. Rechargeable batteries
(NiCd/NiMH) only have a voltage of 1.2 V/cell and therefore are not suitable for power supply to the transmitter
or the charge function that is integrated in the transmitter.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back of the transmitter. Push the locking lever (2) at the upper edge
of the battery compartment lid slightly down and lift off the lid.
Now put the 4 batteries in the battery compartment. Observe the correct polarity of the individual cells. A corresponding
note (3) is located on the bottom of the battery compartment.
Then place the battery compartment lid with the bottom edge first into the transmitter housing and let the latching lever
latch properly when pushing on.

c) Checking the Transmitter's Power Supply

When new batteries are inserted, switch on the transmitter with the function switch (see figure 1, item 7) for test
purposes. For this, push the function switch from the right switch position "OFF" to the left switch position "ON".
To indicate correct voltage supply, the red function control lamp
lights up (see figure 1, item 2), and the transmitter issues a short
signal.
If the power supply is no longer sufficient for proper operation of
the transmitter, the red function indicator lamp starts to flash and
the transmitter emits warnings sounds in a quick sequence. In
this case, stop operation of your model as quickly as possible.
Insert new batteries for further operation of the transmitter.
Attention!
When the receiver electronics in the model have an
integrated protection circuit to prevent unintended start-
up of the drive motor, you also need to make sure before
any commissioning of the transmitter that the control
lever for the motor function (see figure 1, item 4 or 12,
depending on the mode set) is in the "Motor off" position.
For this purpose, the control stick must be pushed down
completely or pulled towards you as far as possible.
Figure 3
37