Operation; Initial Settings; Basic Settings - Sony LT10A Serie Bedienungsanleitung

5. Operation

This sections uses the 2 channel model in its explanations.
The 1 channel model is the same as the 2 channel model
without the B channel.
BCD and RS-232C models are noted in the text.

5-1. Initial settings

An initialization is carried out at the time of shipping;
however it is possible to make the following selections
depending on intended use. Details of the settings at the
time of shipping are given in each section.
• Changing between inches/mm
Turn on power while holding down
Press to change between inches/mm.
Press to set and return to the measuring state.
SET
• Device is set to mm at the time of shipping.
• To change the initial settings hold down the
press the key for approximately 2 seconds.
MODE
Basic operation
: to the next item.
MODE
: Select item.
: Set item.
SET
Note
• Even if you select an item with the
will be mode until you press the
• Once the initial setting mode has been entered it is not
possible to return to the measuring state partway
through. Press the key repeatedly to skip the items.
MODE
LT10A / LT11A Series
and press key.
RESET
MODE
A
key and
SET
key, no changes
key.
SET

5-1-1. Basic settings

1. Setting the display
(2 channel models)
One of the following may be
chosen:
Upper + +
A A B A B
Lower
B A B
When the upper display A+B is
selected, the lower display only
shows the current value of the
s e l e c t e d c h a n n e l a n d n o
operation can be made on the
lower display.
2. Setting the display resolution or direction
(channel A)
0.001/0.005/0.01/–0.001/–0.005/
–0.01 mm
• With the measuring unit's
spindle pushed in:
+: positive direction
–: negative direction
∗ When set to inches, values are chosen from 0.0002,
0.0005, –0.0002, and –0.0005.
Note
With the LT10A series, 0.001 mm and –0.001 mm (0.0001"
and –0.0001") are not avaible.
A
B
+
A B
–
factory-set
A
factory-set (LT11A)
13
(E)