Sony LT10A Serie Bedienungsanleitung Seite 73

2. Setting the data signalling rate
is displayed and the data
signalling rate can be selected.
600/1200/2400/4800/9600/
19200/38400 bps
3. Setting the data length
is displayed and the
data can be set to 7 or 8 bits.
4. Setting the stop-bit
is displayed and the stop
bit can be set to one or 2 bits.
LT10A / LT11A Series
5. Setting the parity
parity can be switched on or off.
Note
When the data length is set to 7 bits
in step 3, select "Parity".
factory-set
6. Selecting odd or even parity
Switches to this mode when
factory-set
7. Selecting the function for the RS-TRG terminal
factory-set
Note
The RS-TRG input cannot be used when
is displayed and the
: No parity
: Parity
is chosen above.
: Odd parity
: Even parity
: Mode for inputting
mechanical contact
outputs (such as relay
and switch outputs).
: Mode for inputting
e l e c t r o n i c c i r c u i t
o u t p u t s ( s u c h a s
transistor outputs).
: To output at a set
interval.
factory-set
factory-set
factory-set
has been selected.
17
(E)