Bcd Model (Only Lt10A-105B/205B, Lt11A-101B/201B) - Sony LT10A Serie Bedienungsanleitung

5-1-2. BCD model
(only LT10A-105B/205B, LT11A-101B/
201B)
Proceeds to the next setting mode from "5-1-1. Basic
settings" step 4.
1. BCD logic
Setting the BCD output logic.
"+" is true logic.
"–" is false logic.
Exception : Logic for the DRQ,
READY, and alarm
terminals cannot be
changed.
(See "7. BCD output")
2. BCD output format
Setting the BCD output format.
: B C D i s
according to the DRQ
signal input, and the
resulting status is held
even if the DRQ signal
goes off.
: B C D i s
a c c o r d i n g t o D R Q
s i g n a l i n p u t , a n d
a s s u m e s
i m p e d a n c e s t a t u s
when there is no DRQ
signal input.
: BCD is output at all times at the set time interval
without the input of the DRQ signal.
LT10A / LT11A Series
factory-set
o u t p u t
o u t p u t
factory-set
h i g h -
3. Automatic BCD output time interval
This mode is established when
has been set in step 2.
Select one of the eight time
intervals listed below.
1/2/4/8/16/32/64/128 ms
(See "7-2. Signal timing" for the
BCD input/output timing)
Initial settings are now complete for the BCD model.
Press to return to the measuring state.
MODE
factory-set
15
(E)