Main Display - Sony LT10A Serie Bedienungsanleitung

Main display

Displays the measured data, setting data for various
modes, or alarms, etc.
Preset status indicator
Peak-hold indicator
P M A X M I N P — P C P H1 2 3 4
A
P M A X M I N P — P C P L1 2 3 4
B
Key lock indicator
Selected channel indicator
Selected channel indicator (2 channel model)
Choose one of these four.
Upper + +
A A B A B
Lower
B A B
• A
: data from measuring unit,
input channel A
B : data from measuring unit,
input channel B
A+B: sum of data from channel A and B
• In order to carry out calculations such as A–B or –A+B,
change the direction of A or B to "+" or "–".
(Initial settings)
LT10A / LT11A Series
Comparator upper
limit setting indicator
mm
Comparator lower
limit setting indicator
mm
+
A B
–
Note
• If upper display A+B and lower display A have been
selected, the comparator setting values of channel A will
be applied on both the upper and lower limits.
• When the upper display A+B is selected, the lower
display only shows the current value of the selected
channel and no operation can be made on the lower
display.
Preset status indicator
When P is displayed the preset value is set.
Peak-hold indicator
When MAX/MIN/P-P is displayed the data shown is the
maximum/minimum/maximum–minimum value.
When neither of the them is shown, the current value is
displayed.
Comparator upper limit setting indicator
Displayed when the comparator value has been set. The
upper digits are the upper limit.
Comparator lower limit setting indicator
Displayed when the comparator value has been set.
The lower digits are the lower limit.
• Up to four different comparator upper and lower limit
settings (CPH1 to CPH4 and CPL1 to CPL4) can be
stored in the memory for LT10A-105B/205B and LT11A-
101B/201B.
• LT10A-105/205/105C/205C and LT11A-101/201/101C/
201C have only one setting each.
Key lock indicator
Lighted when key lock is established; off when key lock is
released.
7
(E)