Sony LT10A Serie Bedienungsanleitung Seite 77

3
Push to set.
SET
"CPH" flashes.
4
Push to select the CPL comparator lower limit
COMP
setting mode. Sign of the CPL value flashes.
5
Same as 2.
6
Push to set.
SET
"CPH" and "CPL" flash.
7
Push to select the mode for setting the channel B
COMP
comparator values.
∗ Single channel models return to the measuring state.

8


9

10

Same as 2, 3, 4, 5, 6.

11


12

13
Push to return to the measuring state.
COMP
LT10A / LT11A Series
Note 1
With the BCD models four different settings can be stored
in memory. The operations are as follows.
A CH CPH1 CPH2
CPL1 CPL2
↓ ↓
B CH CPH1 CPH2
CPL1 CPL2
• When the 4 settings are not required press
repeatedly.
• Changing the 4 different setting values is carried out via
the BCD connector input terminal.
• When the BCD connector is not connected the setting is
CPH1 and CPL1.
Note 2
If is not pressed the previous setting is maintained.
SET
Note 3
When the key is pressed to set the CPL the sign ("+"
SET
or "–") of the CPH value may flash. This is because the CPH
(upper limit) is less than the CPL (lower limit), and the
device is in the CPH setting mode. In this case, return to
and start from the CPH setting.
CPH3 CPH4
CPL3 CPL4
↓ ↓
CPH3 CPH4
CPL3 CPL4
COMP
21
(E)