Sony LT10A Serie Bedienungsanleitung Seite 94

Initial setting :
Outputting with measuring mode information
and comparator Go/No Go result
1st byte
2nd byte
3rd byte
4th byte
5th byte
6th to 11th bytes : Numerical data
Initial setting :
Outputting according to the mode 1
format (statistical calculations) of the
d i g i t a l p r i n t e r P 4 0 ( P 4 0 i s s o l d
separately).
Note
• For the 2 channel model, whether to output B channel
data following a space or to divide it with the delimiter is
selected by the initial setting (See P18, step 9.).
• When set to
mode even the 2 channel model only
outputs the A channel data only.
38
(E)
: Channel name (A or B)
: Current mode
(N: Current value,
P: Peak-to-peak value,
I : Minimum value,
A: Maximum value)
: Unit (M: mm, I: inch)
: Comparator Go/No Go
result
U : Upper limit over
G : Within range
L : Lower limit under
E : When an alarm has
occurred
: Sign ("+" or "–")
(ex.00.000)
2 When an alarm is triggered
Initial setting :
For an overflow alarm
1st byte : Channel name (A or B)
2nd byte : Sign ("+" or "–")
3rd byte : F
4th to 9th bytes : Numerical data
For a non-overflow alarm
1st byte : Channel name (A or B)
2nd byte : E
Initial setting :
1st byte : Channel name (A or B)
2nd byte : E
3rd byte : F (For an overflow alarm)
O (For a non-overflow alarm)
LT10A / LT11A Series