Mounting The Inverter - Steca coolcept Bedienungsanleitung

GB
4.2

Mounting the inverter

Fastening the mounting plate
For Australia only: Mask off the
Note
When the inverter is used in Australia, the national regulations do not permit the Protection
Class II symbol to be displayed on the type plate. The inverter is therefore supplied with a small
sticker in the same bag as the AC plug.
Completely cover the
Fig. 6.
Fig. 6: Position of the sticker for covering the Protection Class II symbol
104
u Screw the mounting plate to the mounting surface using 4
screws:
Use screws (and dowels etc.) appropriate for the weight of
n
the inverter.
The mounting plate must lie flat on the mounting surface
n
and the metal strips at the sides must point forwards (Fig.
left).
Install the mounting plate vertically with the retaining plate
n
① at the top (example in Fig. left).
—————————————————————————
Notice
More information on determining the optimum position for the
mounting plate is provided in the attached information sheet and in
the Appendix under
—————————————————————————
Protection Class II symbol on the type plate.
Protection Class II symbol using the small sticker provided, as shown in
Mounting .
747.431 | Z08 | 2014-01-31