Steca coolcept Bedienungsanleitung Seite 114

GB
Removing the inverter from the mounting surface
114
1. Use one hand to press the retaining plate on the mounting
plate approx. 5 mm towards the mounting surface ① (Fig.
left).
2. Use the other hand to push the inverter upwards, far enough
so that the retaining plate no longer latches ②. Release the
retaining plate.
3. Lift the inverter with both hands until the hooks on the rear
side of the inverter are free ③.
4. Remove the inverter from the mounting surface ④.
747.431 | Z08 | 2014-01-31