GB
2
General information
2.1
General safety instructions
This document is part of the product.
n
Install and use the device only after reading and understanding this document.
n
Always perform the measures described in this document in the sequence specified.
n
Keep this document in a safe place for the entire service life of the device. Pass the document
n
on to subsequent owners and operators of the device.
textvar object does not exist
n
textvar object does not exist
n
textvar object does not exist:
n
–
Device (not functioning, visible damage, smoke, penetration of liquid etc.)
–
textvar object does not exist
–
textvar object does not exist
Do not switch the system on again before
–
the device has been repaired by a dealer or the manufacturer,
–
damaged cables or solar modules have been repaired by a technical specialist.
textvar object does not exist
n
Do not open the casing: Risk of death. Invalidation of the guarantee.
n
Factory labels and markings must never be altered, removed or rendered unreadable.
n
textvar object does not exist (e.g. external data logger). textvar object does not exist.
n
Safety instructions on the device
2
Attention
Présence de deux sources
Isoler les deux sources
de tension
- Réseau de distribution
- Panneaux photovoltaïques
10min
1
S/N: 746867XG001155550005
80
① Dangerous voltages can remain present on the compo-
nents up to 10 minutes after switching off the DC circuit
breaker and the line circuit breaker.
② Warning. There are 2 voltage sources present: power grid,
3
solar modules.
③ Disconnect both voltage sources from the device before
working on the device: the solar modules via the DC cir-
avant toute
intervention
cuit breaker and the power grid via the line circuit
breaker.
④ Read and follow the instructions!
⑤ Serial number as a barcode and in plain text
4
5
747.431 | Z08 | 2014-01-31