Maintenance And Disposal; Maintenance; Disposal - Steca coolcept Bedienungsanleitung

GB
8

Maintenance and disposal

8.1

Maintenance

The inverter is basically maintenance-free. Despite this, it is a good idea to regularly check that the
cooling fins on the front and rear sides of the device are free of dust. Clean the inverter when neces-
sary as described below.
ATTENTION!
Danger of destruction of components in devices of type coolcept:
– Do not allow cleaning agents and devices to penetrate between the cooling fins at the front
of the inverter (under the grey hood).
– Do not use especially the following cleaning agents:
– Solvent-based cleaning agents
– Disinfection agents
– Coarse or sharp-edged cleaning agents
Removing dust
Dust should be removed using compressed air (max. 2 bar).
Removing heavy soiling
DANGER!
Risk of death by electrocution! Use cleaning agents only with a slightly damp cloth.
1. Remove heavy soiling with a slightly damp cloth (use clear water). If necessary, use a 2 %
hard soap solution instead of water.
2. After cleaning, remove any soap residue using a slightly damp cloth.
8.2

Disposal

Do not dispose of the device in the normal household waste. At the end of its service life, return the
device to Steca Customer Service with a note stating
The device packaging consists of recyclable materials.
132
Zur Entsorgung (For disposal) .
747.431 | Z08 | 2014-01-31