Installation; Mounting; Mounting Location; Mounting The Inverter - Steca PI 1100 Montageanleitung Und Bedienungsanleitung

4

Installation

4.1 Mounting

4.1.1 Mounting location
Ensure that the mounting location satisfies the following requirements:

• Mount in a dry, dust-free indoor room.
• Mount on even surface.
• Mount upright on the wall, on concrete or on any other non-flammable
surface.
• The mounting location must be protected from unauthorized access, espe-
cially by small children.
• Distance between inverter and battery: please note that the pre-fitted cables
must not be extended.
• Minimum clearance of approx. 0 cm above and below to allow free air circu-
lation.
4.1.2 Mounting the inverter
Mark and drill the upper holes (Ø 8 mm).

Insert the dowels and screw in the screws. Do not yet screw tight!

Hang the inverter on the two screws and mark the lower holes.

Remove the inverter and drill the two lower holes.

Insert the dowels.

Hang the inverter on the two upper screws and screw in the lower screws.

Screw all screws tight.

The mounting of the inverter is now complete.

0
EN
191
191
75.58 | 09.37
Fuse
190,23
Fuse
Fuse
- -
+ +
+
-
+
191
190,23
-
+
Netz
-
+
Netz
Netz
-
190,2